This 5-day course is directed primarily to instrument engineers and technicians who will be responsible for the installation and 1st Line Maintenance of PROVOX DCS. By the end of the course delegates will be able to:

• Operate the PROVOX system using the PROVUE/OWP console and/or ENVOX terminal
• Handle 1st Line hardware modifications for the SR90/SRx controllers
• Analyze faults detected during the operations and isolate faults to card level
• Utilize and interpret the ENVOX based diagnostic routines
  

Day 1: System Hardware Overview

Introduction. AC/DC Distribution. Power Supply. Highway diagnostics/Trouble Shooting.

Day 2: Operator Consoles

Review day 1. Console Types. Hardware Layout. Diagnostics. Trouble Shooting.

Day 3: ENVOX Diagnostic

Review day 2. Data Manipulation. Software/Hardware Fault Diagnostics Routines

Day 4: Controllers

Review day 3. Controller Types. I/O Cards, Termination Panels, hardware fault diagnostics.

Day 5: Preventive Maintenance

Review day 4. Preventive Maintenance Tasks Handling. Documentation. Evaluation.

Prerequisites

Course 5170, Basic Configuration of PROVOX DCS

Topics

• The Course is divided into four parts
  1. System Hardware Overview.
  2. Consoles.
  3. ENVOX/PROFLEX Based on Diagnostic Routines.
  4. Controllers, diagnostic routines
  5. Preventive Maintenance
  
• Each day will be divided into 2 theoretical and 2 practical parts. During the practical part the delegates will apply the theory on a boiler control model. Apart from these workshops, it is also possible for the delegates to submit their own configuration in advance, which can be discussed and/or worked on during the course.

The number of participants will be limited to two persons per console to ensure sufficient practical work for all concerned.

Cost:  Call to discuss